Komatsu — 5000 HOUR LUBRICATION AND MAINTENANCE CHECKS

Maintenance - Section 4 OM4042 Page 40-10 Lubrication and Service 3. 4. 5. 1000 HOUR LUBRICATION AND MAINTENANCE CHECKS Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIA HYDRAULIC TANK - Drain hydraulic oil and clean inlet strainer. Refill tank with new oil, approximate capacity 134 gal. (507 l). Use Lube Key B. RADIATOR - Clean cooling system with a quality cleaning compound. Flush with water. Refill system with DCA or anti-freeze and water solution. Check Cooling System Recommendation Chart for correct mixture.

FUEL TANK - Remove breather and clean in solvent. Dry with air pressure and reinstall. ENGINE - Remove, clean and dry crankcase breather elements. OPERATOR'S SEAT - Apply grease to slide rails. Use Lube Key D. Maintenance for every 10, 50, 100, 250 & 500 hour NOTE: Lube Key references are to the Lubrication Lubrication and Maintenance Checks should also be Specification Chart. carried out at this time.

5000 HOUR LUBRICATION AND MAINTENANCE CHECKS Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIA FRONT WHEELS - Drain oil and completely disas- semble and check all parts for wear or damage. Refer to Section G of the service manual for Disassembly and Assembly procedures. Refill with oil. Check the oil level at oil level plug on wheel hub. Lube Key C. Check wheel bearing preload at the first 500 hours after each rebuild. AIR CLEANERS - Clean the Donaclone Tubes in the pre-cleaner section of the air filter.

Use low pressure cold water or low pressure air to clean tubes. Refer to Section C of the service manual. Maintenance for every 10, 50, 100, 250, 500 & 1000 NOTE: Lube Key references are to the Lubrication hour Lubrication and Maintenance Checks should also Specification Chart. be carried out at this time. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIA LS HYDRAULIC TANK - Drain hydraulic oil and clean inlet strainer. Refill tank with new oil, approximate capacity 134 gal. (507 l). Use Lube Key B.

RADIATOR - Clean cooling system with a quality cleaning compound. Flush with water. Refill system with DCA or anti-freeze and water solution. Check Cooling System Recommendation Chart for correct mixture. FUEL TANK - Remove breather and clean in solvent. Dry with air pressure and reinstall. ENGINE - Remove, clean and dry crankcase breather elements. OPERATOR'S SEAT - Apply grease to slide rails. Use Lube Key D.

Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIA LS FRONT WHEELS - Drain oil and completely disas- semble and check all parts for wear or damage. Refer to Section G of the service manual for Disassembly and Assembly procedures. Refill with oil. Check the oil level at oil level plug on wheel hub. Lube Key C. Check wheel bearing preload at the first 500 hours after each rebuild. AIR CLEANERS - Clean the Donaclone Tubes in the pre-cleaner section of the air filter. Use low pressure cold water or low pressure air to clean tubes.

Refer to Section C of the service manual.