hitachi — REMOVE AND INSTALL BUCKET

FRONT ATTACHMENT / Front Attachment REMOVE AND INSTALL BUCKET Removal 1. Lower the bucket bottom onto the ground and set the arm in vertical against the ground contacting surface. 2. Remove nut (2). Remove split type O-rings (1) (4 used) from the bucket. : 8 mm 3. Remove bolts (5) (3 used) from stopper (4). Re- move stopper (4) from pin (3). : 30 mm W1J7-04-01-020 CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. CAUTION: Pin (3) weight: 82 kg (180 Ib) 4. Slowly pull out pin (3) to the position where the bucket can be removed from link A.

Attach a nylon sling onto the body of pin (3) and hoist pin (3). Remove pin (3) from the bucket. IMPORTANT: Put a soft waste under link A and the bucket cylinder in order not to damage the arm. 5. Start the engine. Slowly retract the bucket cylinder. Secure link A and the bucket cylinder rod side to the arm. Stop the engine. M1J1-07-074 Bucket Cylinder Arm Link A 3 Bucket W1J7-04-01-021 Bucket Cylinder 5 4 Bucket W1J7-04-01-022 W4-1-2 Bu 1 2 1 M