hitachi — MAIN POINTS TO RELEASE PRESSURE

FRONT ATTACHMENT / Cylinder MAIN POINTS TO RELEASE PRESSURE 1. Position the front attachment as illustrated. 2. Start engine. (at slow idle speed) 3. Remove the gum cap. Loosen the air bleed plug. NOTE: As for the loader front, almost same main points should be followed. CAUTION: Escaping fluid under high pressure may penetrate the skin and eyes, and cause serious injury. Release the pressure before removing the hydraulic or other lines. Hot hydraulic oil just after operation may spout and cause severe burns. Wait for oil in order cool before starting any work. : 19 mm 4. Operate cylinder to extend and retract. Bleed air out until only oil flow out from the plug hole. 5.

Tighten the plug and install the gum cap. : 19 mm : 44 ± 2.9 N m (4.5 ± 0.3 kgf m, 33.0 ± 2.2 lbf ft) Positions for Air Bleed Plug Air Bleed Plug (Arm Cylinder) Air Bleed Plug (Boom Cylinder) Air Bleed Plug (Bucket Cylinder) W1JB-04-02-006 W4-2-14