Toyota — TROUBLESHOOTING

2-17 INSPECTION 1. Power supply voltage check OK (200 to 220 V) To inspection 2 NG (0 V, abnormal voltage drop or lack of phase) Power supply defect INSPECTION 2. Power supply plug terminal voltage inspection OK (200 to 220 V) To inspection 3 NG (0 V, abnormal voltage drop or lacking phase) Power cable defect INSPECTION 3. Charger timer test See the TIMER TEST section (page 2-15). OK (200 to 220 V) See “4. Charging cpmpletes normally but the charge is insufficient.” of “No diagnosis error code is displayed” on page 2-24. NG (0 V, abnormal voltage drop or lack of phase) Display defect INSPECTION 4.

DC side fuse continuity inspection AC power plug disconnected, charging buttons off and fuse removed OK (0 Ω ) See “4. Charging cpmpletes normally but the charge is insufficient.” of “No diagnosis error code is displayed” on page 2-24. NG ( ) Blown fuse Measurement terminals Power supply terminal Tester range 250 VAC Standard 200 to 220 V Measurement terminals Power plug terminals Tester range 250 VAC Standard 200 to 220 V Measurement terminals Both terminals of DC fuse Tester range Ω × 1 Standard 0 Ω