2-39 Push the reset lever lightly to reset the thermal relay. [POINT 3] Inspection: Inspect the transformer insulation. Standard: 0 Ω [POINT 4] Inspection: Inspect the diode in installed state on the fin. Remove it only when an abnormality is found. Inspection: As two diodes having different polarities are used, install in the correct direction. Note: In the case of the charger for batteries with the capacity at 320 AH/5 HR or less, the diode mounting direction is the reverse of the direction shown in the figure. Circuit tester range Ω × 1 Measurement terminals Forward Anode (−) − Cathode (+) Reverse Anode (+) − Cathode (−) Standard value Forward See the Service Standards list. Reverse ∞ Ω