Operation Section Inching Watch the road carefully for any obstacle when driving the truck. Do not go fast over bumps, pot holes or other rough grounds, otherwise the engine might go OFF by a severe impact. NOTE: The purpose of the inching pedal is to provide precise lift truck inching control at very slow travel speed and high engine rpm. This is used for fast hydraulic lift during load approach, pick up or load positioning. In case of engine going OFF, press the brake pedal at one time as hard as possible in order to stop the truck. Pressing the brake pedal several times has a risk that the brake would not work. Typical Example 1.
To inch (creep) in either direction, slowly push down on the inching pedal. This will start to apply the service foot brakes and allow the transmission clutch discs to slip. 2. Vary the position of inching pedal and the accelerator pedal to control the inching speed and distance. 3. Pushing down further on the inching pedal will disengage the transmission completely and apply the service brakes fully to stop and hold the lift truck. This will provide full engine power for fast hydraulic lift. 13. To stop the lift truck when travelling in either direction, RELEASE accelerator pedal (1). 14. PUSH DOWN on service foot brake pedal (2) and bring the lift truck to a smooth stop.
Typical Example 106 WARNING