Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section Tire Inflation Information Tire Shipping Pressure The tire inflation pressures shown in the following chart are cold inflation shipping pressures. Standard tire, ply rating and inflation pressures. The operating inflation pressure is based on the weight of a ready-to-work machine without attachments, at rated payload, and in average operating conditions. Pressures for each application may vary and should always be obtained from your tire supplier. NOTE: Fill tires to the recommended pressures listed ± 35 kPa (5 psi). Tires can be filled with nitrogen.

Tire Inflation Pressures Adjustment A tire inflation in a warm shop area, 18° to 21°C (65° to 70°F), will be underinflated if the machine works in freezing temperatures. Low pressure shortens the life of a tire. Tires Inflation Personal injury or death could result when tires are inflated incorrectly. Use a self-attaching inflation chuck and stand behind the tread when inflating a tire. Proper inflation equipment, and training in using the equipment, are necessary to avoid overinflation. A tire blowout or rim failure can result from improper or misused equipment. Always remove (deflate) all air from a single tire and from both tires on a dual assembly before changing them.

NOTICE When changing tires, change them in sets, even if only one of the tires is damaged. If new and used tires are used on the same axle, tilting of the mast and rapid tire wear will result. The mounting faces of the hub, wheel nuts and wheels must be free of any foreign material and lubricants of any kind. Tighten wheel nuts again after 24 hours of operation. Do not reinflate a tire that has been driven on while flat or underinflated, without first checking to be sure the locking ring on the wheel is not damaged and in position. Always deflate tires before changing them.

125 WARNING Size Ply Rating Or Strength Index Shipping Pressure kPa psi 8.25 x 15 14PR 790 115 8.25 x 15 16PR 880 128 9.00 x 20 14PR 790 115