Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section Torque Specifications Torques for Standard Bolts, Nuts and Taperlock Studs Metric Hardware - This lift truck is almost totally metric design. Specifications are given in metric and U.S.Customary measurement. Metric hardware must be replaced with metric hardware. Check parts books for proper replacement. NOTE : Use only metric tools on most hardware for proper fit. Other tools could slip and possibly cause injury. Torques for Standard Hose Clamps - Worm Drive Band Type NOTICE The following charts give general torques for bolts, nuts and taperlock studs or SAE Grade 5 or better quality.

Torques for Bolts and Nuts With Standard Threads NOTICE The following chart gives the torques for initial installation of hose clamps on new hose and for reassembly or retightening of hose clamps on existing hose. 1 1 Newton meter (N m) is approximately the same as 0.1 kg m. 1 1 Newton meter (N m) is approximately the same as 0.1 kg m.

126 Thread Size Inch Standard Nut and Bolt Torque N•m lb•ft 1/4 12 ± 4 9 ± 3 5/16 25 ± 7 18 ± 5 3/8 45 ± 7 33 ± 5 7/16 70 ± 15 50 ± 11 1/2 100 ± 15 75 ± 11 9/16 150 ± 20 110 ± 15 5/8 200 ± 25 150 ± 18 3/4 360 ± 50 270 ± 37 7/8 570 ± 80 420 ± 60 1 875 ± 100 640 ± 75 1 1/8 1100 ± 150 820 ± 110 1 1/4 1350 ± 175 1000 ± 130 1 3/8 1600 ± 200 1180 ± 150 1 1/2 2000 ± 275 1480 ± 200 Clamp Width Initial Installation Torque On New Hose N•m1 lb•in 16 mm (.625 in) 7.5 ± 0.5 65 ± 5 13.5 mm (.531 in) 4.5 ± 0.5 40 ± 5 8 mm (.312 in) 0.9 ± 0.2 8 ± 2 Clamp Width Reassembly or Retightening Torque On Existing Hose N•m1 lb•in 16 mm (.625 in) 4.5 ± 0.5 40 ± 5 13.5 mm (.531 in) 3.0 ± 0.5 25 ± 5 8 mm (.312 in) 0.7 ± 0.2 6 ± 2