Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section Torques for Taperlock Studs Torques for Metric Fasteners Be very careful never to mix metric with U.S. customary (standard) fasteners. Mismatched or incorrect fasteners will cause lift truck damage or malfunction and may even result in personal injury. Original fasteners removed from the lift truck should be saved for reassembly whenever possible. If new fasteners are needed, they must be of the same size and grade as the ones that are being replaced. The material strength identification is usually shown on the bolt head by numbers (8.8, 10.9, etc). The following chart gives standard torques for bolts and nuts with Grade 8.8. NOTICE NOTE:

Metric hardware must be replaced with metric hardware. Check parts book for proper replacement. 1 1 Newton meter (N•m) is approximately the same as 0.1 kg•m. 1 1 Newton meter (1 N•m) is approximately the same as 0.1 kg•m. 2 ISO - International Standards organization.

127 Thread Size Inch Standard Taperlock Stud Torque N•m1 lb•ft 1/4 8 ± 3 6 ± 2 5/16 17 ± 5 13 ± 4 3/8 35 ± 5 26 ± 4 7/16 45 ± 10 33 ± 7 1/2 65 ± 10 48 ± 7 5/8 110 ± 20 80 ± 15 3/4 170 ± 30 125 ± 22 7/8 260 ± 40 190 ± 30 1 400 ± 60 300 ± 45 1/8 500 ± 700 370 ± 50 1/4 650 ± 80 480 ± 60 3/8 750 ± 90 550 ± 65 1/2 870 ± 100 640 ± 75 Thread Size Metric Standard Torque N•m1 lb•ft M6 12 ± 4 9 ± 3 M8 25 ± 7 18 ± 5 M10 55 ± 10 41 ± 7 M12 95 ± 15 70 ± 11 M14 150 ± 20 110 ± 15 M16 220 ± 30 160 ± 22 M20 450 ± 70 330 ± 50 M24 775 ± 100 570 ± 75 M30 1600 ± 200 1180 ± 150 M36 2700 ± 400 2000 ± 300