Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section Coolant Water Hard water, or water with high levels of calcium and magnesium ions, encourages the formation of insoluble chemical compounds by combining with cooling system additives such as silicates and phosphates. The tendency of silicates and phosphates to precipitate out-of-solution increases with increasing water hardness. Hard water, or water with high levels of calcium and magnesium ions encourages the formation of insoluble chemicals, especially after a number of heating and cooling cycles. DOOSAN prefers the use of distilled water or deionized water to reduce the potential and severity of chemical insolubility.

Use a greater concentration (above 50%) of commercially available automotive antifreeze only as needed for anticipated outside (ambient) temperatures. Do not exceed the recommendations, provided with the commercially available automotive antifreezes, regarding the coolant mixture of antifreeze to water. Make proper antifreeze additions. Adding pure antifreeze as a makeup solution for cooling system top-up is an unacceptable practice. It increases the concentration of antifreeze in the cooling system which increase the concentration of dissolved solids and undissolved chemical inhibitors in the cooling system.

Add antifreeze mixed with water to the same freeze protection as your cooling system. Use the chart below to assist in determining the concentration of antifreeze to use. ppm = parts per million Using water that meets the minimum acceptable water requirement may not prevent drop-out of these chemical compounds totally, but should minimize the rate to acceptable levels. Antifreeze DOOSAN recommends using automotive antifreeze suitable for gasoline engines having aluminum alloy parts. Antifreeze of poor quality will cause corrosion of the cooling system, and thus always use automotive antifreeze prepared by a reliable maker, and never use it mixed with antifreeze of different brand.

DOOSAN recommends that the coolant mix contain 50% commercially available automotive antifreeze, or equivalent and acceptable water to maintain and adequate water pump cavitation temperature for efficient water pump performance. Premix coolant solution to provide protection to the lowest expected outside (ambient) temperature. Pure undiluted antifreeze will freeze at –23°C (- 10°F).

NOTICE 129 Acceptable Water Water Content Limits (PPM) Chlorides (Cl) 50 maximum Sulfates (SO4) 50 maximum Total hardness 80 mg/l Total solids 250 maximum PH 6.0 to 8.0 Antifreeze Concentrations Protection Temperature Concentrations Protection to -15 °C (5 °F) 30% antifreeze and 70% water Protection to -23 °C (-10 °F) 40% antifreeze and 60% water Protection to -37 °C (-34 °F) 50% antifreeze and 50% water Protection to -51 °C (-60 °F) 60% antifreeze and 40% water