Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section Oil Cooled Disc Brake (OCDB) Type Park the lift truck on a level surface. Apply the parking brake. Place the directional control level in NEUTRAL and stop the engine. Typical Example 8. Remove planetary hub level/drain/fill plugs. Allow the oil to drain completely out. Reinstall the planetary hub plugs. 9. Fill the drive axle housing with sufficient fresh oil through the drive axle housing level/fill plug opening until it reaches the bottom of the hole. See the section, "Lubricant the Viscosities." and "Refill Capacities" for the type and amount of oil to use. 10. Remove the wood blocking and Lower the carriage. 11. Operate the lift truck for a few minutes.

And align the planetary hub drain/fill/level plugs to the horizontal position. Remove the plugs. 12. Fill the planetary hubs, through the drain/fill/level hole, until the oil reaches the hole. See the section, "Refill Capacities". 13. Clean and reinstall the planetary hub drain/fill/ level plugs. 1. Remove three drain plugs of the drive axle housing and both wheel ends. Allow the oil to drain into a suitable container. Clean the magnetic drain plugs. Check O-ring seal and replace if necessary. 2. Install the drain plug. 3. Remove strainer assembly. 4. Wash the strainer assembly in clean, nonflammable solvent and dry it. 5. Install the strainer assembly and reconnect the hose and harness. 156