Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section Parking Brake - Test, Adjust To prevent personal injury, the operator must be ready to use the service brake if the parking brake is not adjusted correctly and the lift truck starts to move. 6. Remove the dip stick/filter cap. Fill the drive axle housing with oil. See "Lubricant Specification - Drive Axle Oil" and "Refill Capacity". 7. Start the lift truck. With the engine at low idle, place the directional control lever to the NEUTRAL. 8. Maintain the oil level between lower mark and upper mark on the dip stick/filter cap. 9. Install the dip stick/filter cap. NOTE: Be sure area around the lift truck is clear of personnel and obstructions. 1.

Drive the lift truck with a rated load up a 15% incline. 2. Halfway up the incline, stop the lift truck by applying the service brakes. Typical Example 3. Engage the parking brake and slowly release the service brake. 4. If the parking brake has the correct adjustment the lift truck will be hold in place. If the parking brake does not hold, adjust the parking brake. 157 WARNING