Doosan D80S-5 — Doosan D80S-5 User Manual

Maintenance Section 19. Start the engine and operate the hydraulic controls, and the steering system, through a few cycles to fill the lines. Look for oil leaks. 20. Stop the engine and check the oil level. With all cylinders retracted, maintain the oil level to the FULL mark on the dip stick/filter cap assembly. Transmission Oil & Filter (3 Speed Only) – Change Lift Chains - Test, Check, Adjust Lift Chain Wear Test Inspect the part of the chain that is normally operated over the cross head roller. When the chain bends over the roller, the movement of the parts against each other causes wear. Inspect to be sure that chain link pins Do not extend outside of the link hole.

If any single link pin is extended beyond its connecting corresponding link, it should be suspected of being broken inside of its link hole. Lift chains are required to check for weare about every 1,000 service hours or 6 months. Chain wear test is a measurement of wear of the chain links and pins. Take the following steps to check chain wear. 1. Lift the mast and carriage enough for getting tension on lift chains. Only for D50/60/70/80/90S-5 (3 Speed) See topic, "Transmission Oil & Oil Filter - Change" in "First 50-100 Service Hours or a Week".

Transmission Oil (2 Speed Only) – Change Only for D50/60/70S-5 (2 Speed), G50/60/70S-5 See topic, "Transmission Oil & Oil Filter - Change" in "First 50-100 Service Hours or a Week". Typical example 2. Measure precisely ten links of chain distance at the center of pins in millimeter. 3. Calculate chain wear rate*. 4. If the chain wear rate is 2% or more, replace the lift chain. 175