Doosan Mega 500-V (Tier II) — Procedure to Start AEB

S0802195K Page 48 Electrical System AEB STARTER INTRODUCTION The AEB - Starter is s tool to start the AEB of ergo power transmissions by an easy way. It’s useful to work with the ZF - Display because you get all messages about the AEB state via the Insite ZF-Display. The AEB - Starter itself doesn’t show any informations. The AEB-starter works with the diagnostic plug which is in the electric box. 4P 9P To insure the highest level of shift quality, AEB must be done under following conditions: 3 124 FE GHAD JCB Datalink Harness • Before putting the vehicle into AWS0570L service Figure 28 • When the transmission or TCU been replaced. NOTE:

The error code "F6" will be shown in the display as long as the AEB is not done. LIST OF ABBREVIATIONS AEB: Automatic Filling Parameter Adjustment TCU: Transmission Control Unit PROCEDURE TO START AEB Step to do Display message Remarks 1 Warm up transmission Normal operating messages 2 Turn off starter switch Nothing 3 Plug in AEB-starter 4 Bring shift lever to "N" position. Engage park brake.

5 Start engine "PL" TCU must recognize PL for at least 2s before you can press the button 6 Put engine speed to 800 rpm "PL" if start conditions are ok 7 Press button of the AEB-Starter "ST" if start conditions are ok The button must not be released before TCU has started the AEB or quit whit an error code 8 Hold button until AEB has started "K1" … (Information about the AEB state) TCU has started the AEB, and goes on adjusting K1, K2, …, KR. (Button may be released) 9 Wait until AEB has finished "OK" (AEB has been successful)