Doosan Mega 500-V (Tier II) — Display During AEB-mode

DISPLAY DURING AEB-MODE S0802195K Page 49 Electrical System Step to do Display message Remarks 10 Turn off starter switch and unplug AEB-Starter Nothing Symbol Meaning Remarks PL AEB - Starter is plugged at the diagnostic plug ST AEB-Starter-button is pressed K1… K4,KV,KR Calibrating clutch K1… K4,KV,KR - and Kx Wait for start, initialization of clutch Kx, x:

1, 2, 3, 4, V, R ≡ and Kx Fast fill time determination of clutch Kx = and Kx Compensating pressure determination of clutch Kx OK Calibration for all clutches finished Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) after removing AEB-Starter STOP AEB canceled (activation stopped) Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) STOP and Kx AEB stopped, clutch Kx can’t be calibrated Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) Spanner and Kx Kx couldn’t be calibrated, AEB finished Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) ↑ E Engine speed too low, → raise engine speed ↓ E Engine speed too high, → lower engine speed ↑ T Transmission oil temperature too low → heat up transmission ↓ T Transmission oil temperature too high → cool down transmission FT Transmission temperature not in defined range during calibration Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) FB Operating mode not NORMAL or transmission temperature sensor defective or storing of calibrated values to EEPROM-has failed.

Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) FO Output speed not zero _ _ Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) FN Shift lever not in Neutral position Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) FP Parking brake not applied _ _ Transmissions stays in neutral, you have to restart the TCU (starter switch off/on) STOP AEB - Starter was used incorrect or is defective Transmissions stays in neutral, you have to restart the TCU (starter switch off/on)