Komatsu — PRECAUTIONS WHEN TRAVELING UP OR DOWN HILLS

OPERATION OPERATION PRECAUTIONS WHEN TRAVELING UP OR DOWN HILLS WARNING Always observe the following to prevent the machine from tipping over, running away, or slipping to the side. Do not turn on slopes or travel across slopes. If it is necessary to change the direction of travel, always go down to a flat place to change the direction of travel. It is extremely dangerous to travel across slopes or to travel in a horizontal line on slopes.When traveling on slopes, there is danger of turning over and causing a serious accident. Always observe the following.

There is danger of serious damage or injury being caused by the machine tipping over when traveling on slopes, so always observe the following. Do not operate the machine on slopes of more than 15є (Green range (A) of Inclinometer). On slopes of a grade of 10 - 15є (Yellow range (B) of Inclinometer), set the speed selector switch to the Low position, run the engine at 1/2 throttle or below, and travel in a straight line. The following is a guideline for safety. The stability may vary greatly according to the condition of the road surface. Check carefully that the situation is safe before starting operations. Do not travel across slopes, or travel at an angle, or zigzag.

When dumping a load, the steeper at the slope is, the more the engine speed should be reduced when trav- eling. If it is too fast, there is danger that the machine may not stop. When stopping on slopes, return the travel lever slowly. Do not load the machine above the specified maxi- mum payload. Travel at a low speed when traveling on grass, fallen leaves, or wet steel plates. Even on slight slopes, there is danger that the machine may slip. If the engine stops on a slope, never operate the swing lever. The dump body may swing under its own weight. Always stop the Machine when opening or closing the door (cab specifications).

The operating effort may change suddenly because of the weight of the door, 3-64