OPERATION OPERATION HANDLING RUBBER SHOES SKILLFUL USE OF RUBBER SHOES Comparison of rubber shoes and metal shoes Considering the properties of the material used, rubber shoes offer various advantages. However, their weak point is lack of strength. Therefore, it is important to understand the advantages of rubber shoes, and to follow the pre- cautions regarding handling and prohibited work. This will extend the life of the rubber shoes and will enable the machine to display the advantages of rubber shoes to the maximum. Before using rubber shoes, always read "PRECAUTIONS WHEN USING RUBBER SHOES (PAGE 3-70)".
WARRANTY FOR RUBBER SHOES It is important to inspect and maintain the tracks at the correct tension. Furthermore, these shoes must not be used near objects where they are likely to suffer damage, such as the corners of steel plates, U-shaped grooves, and blocks, on crushed rock or the sharp edges of rocks, iron beams or scrap iron. If the customer carries out prohibited work or does not follow the precautions for operation, the damage resulting from the customer’s mistaken use of the machine shall not be included in the scope of the warranty. PRECAUTIONS WHEN USING RUBBER SHOES Prohibited work Do not carry out the following types of work.
Carrying out operations and steering on crushed rock, extremely rough hard rock, steel beams, scrap iron, or near the edges of steel plates will cause damage to the rubber shoes. In places such as riverbeds where there are large numbers of large and small boulders, the stones may get caught and damage the rubber shoes or make the shoes come off. If travel operations are carried out when the shoes slip, this will also reduce the life of the rubber shoes. Be careful not to get oil, fuel, or chemical solvent on the rubber shoes. If such a substance should get on the shoes, remove it immediately. Furthermore, do not travel on road surfaces where oil has collected.
When putting the machine into long-term storage (3 months or more), store the machine indoors where it is protected from direct sunlight or rain. Do not use the machine in high temperature areas, such as areas where there is burning wood, steel plate that have been left under the hot sun, or places where asphalt is being laid. 3-70