OPERATION OPERATION PRECAUTIONS WHEN USING Be careful of the following points when carrying out work. Avoid carrying out counterrotation turns on concrete surfaces. Avoid making sudden changes in direction. This may cause premature wear or damage to the rubber shoes. Avoid operating the steering when traveling over places where there is a big difference in height. When travel- ing over obstacles or places where there is a difference in height, drive the machine at right angles to the obstacles to prevent the shoes from coming off. Avoid doing work with materials that produce oil when crushed (soya beans, corn, or vegetables squeezed for oil), or wash the machine after using it.
Avoid handling materials that will attach the adhesion of the steel core such as salt, ammonium sulphate, potassium chloride, potassium sulphate, calcium superphospate; or wash the machine after use. The adhesion of the core will be attacked by salt, so avoid using the machine in coastal areas. When handling salt, sugar, wheat, or soya beans, if there is any deep cut in the rubber shoes, these sub- stances may get into the lugs or cut portion of the rubber, so always repair the rubber before use. Do not carry out work that involves scraping against walls or concrete embankments. Rubber shoes slip extremely easily on snow or frozen roads.
Be careful not to slip when traveling or working on slopes. The properties of rubber shoes change when working in extremely cold places, and this will reduce the life of the rubber shoe. Because of the properties of rubber, use the rubber shoes within a range of -25єC - +55єC (-13єF - 131єF). To prevent the shoes from coming off, always maintain the correct tension. If the tracks are slack, the shoes will come off under the following conditions. Even when the tension is correct, be extremely careful when car- rying out these operations. 1. When traveling over curbs, rocks, or places where there is a big difference in level (approx. 20 cm (8 in)), do not turn the machine.
When traveling over such objects, always travel at right angles to the object. 2. When traveling in reverse up a slope, do not turn when moving from flat ground onto the slope. If it is necessary to turn on slopes, be sure to turn gradu- ally. 3-71