Komatsu — AFTER STORAGE

LONG-TERM STORAGE OPERATION LONG-TERM STORAGE BEFORE STORAGE When putting the machine in storage for a long time (more than one month), do as follows. Clean and wash all parts, then store the machine indoors. If the machine has to be stored outdoors, select level ground and cover the machine with canvas. Completely fill the fuel tank. This prevents moisture from collecting. Lubricate and change the oil before storage. Disconnect the negative terminals of the battery and cover it or remove it from the machine and store it sepa- rately. Store the machine with the dump body lowered. Lock each control lever and pedal with the lock lever and pedal lock.

To prevent rust, fill with Komatsu genuine supercoolant (AF-NAC) to give a density of at least 30% for the engine coolant. DURING STORAGE WARNING If it is unavoidably necessary to carry out the rust-preventive operation while the machine is indoors, open the doors and windows to improve ventilation and prevent gas poisoning. Operate the engine and move the machine for a short distance once a month so that a new film of oil will be coated over movable parts and component surfaces. At the same time, also charge the battery. For machines equipped with car cooler, run the car cooler.

AFTER STORAGE NOTICE If the machine is to be used when the monthly rust prevention operation has not been carried out, please contact your Komatsu distributor. When using the machine after long-term storage, do as follows before using it. Wipe off the grease from the hydraulic cylinder rods. Add oil and grease to all places. When a machine is stored for a long period, the moisture in the air will get into the oil. Check the oil at all parts before and after starting the engine. If there is oil in the water, change all the oil. 3-82