MAINTENANCE SERVICE PROCEDURE CRACKS IN RUBBER SHOE If the cracks between the rubber shoe lugs increase to a size of approx. 60 mm (2.36 in) the rubber shoe must be repaired. Even if the track is small and short, if the steel cord can be seen inside, carry out repairs immediately. If the length is less than 30 mm (1.18 in) or the depth of the crack is less than 10 mm (0.39 in), there is no particular need to carry out repairs. When making judgement whether to replace, repair, or con- tinue using rubber shoes, please contact your Komatsu distrib- utor. CHECK AND ADJUST TRACK TENSION WARNING Carry out this operation with two workers.
The operator must move the machine in accordance with the signals from the other worker. The wear of the rubber shoe will vary with the working conditions and type of soil. Therefore, it is necessary to inspect the wear and track tension frequently. After new tracks are installed or on a new machine, the track tension lowers in the first 5 - 30 hours of machine operation. If the track tension is adjusted frequently until the initial loosening is completed, the shoes will not detach due to insufficient track tension. CHECKING Drive the machine in reverse on level ground, stop the machine, then put a straight rod between the No.
2 carrier roller and the idler as shown in the diagram on the right. If the clear- ance between the rod and the shoe at the center is 5 - 15 mm (0.197 - 0.6 in), the tension is within the standard range. If the tension is not within the standard range, adjust as follows. 4-27