SERVICE PROCEDURE MAINTENANCE EVERY 250 HOURS SERVICE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. Prepare the following. Container to catch drained oil: Min. 19 liters capacity Refill capacity: 19 liters (10.03 US gal) Filter wrench 1. Swing the upper structure so that drain plug (P) is between the left and right tracks, then stop the engine. 2. Place a drain container under drain valve (P) located on the bottom of the machine. 3.
Loosen drain valve (P) slowly to avoid getting oil on your- self, and drain the oil. 4. Check the drained oil, and if there are excessive metal particles or foreign material, please contact your Komatsu distributor. 5. Install drain valve (P). 6. Open the side cover and lock it securely in position with the side cover support lever (1). 7. Using a filter wrench, turn filter cartridge (2) to the left and remove it. 8. Clean the filter holder, coat the seal surface of the new fil- ter cartridge with engine oil (or coat thinly with grease), then install. REMARK Check that there is no old packing affixed to the filter holder.
If there is any old packing affixed to the filter, it will cause leakage of oil. 9. When installing, bring the packing surface into contact with the seal surface of the filter holder, then tighten a further 1/2 - 3/4 turns. 10. After replacing the filter cartridge, add engine oil through oil filler port (F) until the oil is between the H and L marks on level gauge (G). 11. Run the engine idle for a while, then stop the engine and confirm that the oil level is between the H and L lines according to "CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL (PAGE 3-37)". 4-34