MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before starting the operation. If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare hexagon wrench (width across flats: 8 mm) 1. Set so that the height of plug (F) is at the center of the final drive case, and so that plug (P) is lower than plug (F). 2. Remove plug (F) using the hexagonal wrench. When the oil level reaches a point 10 mm below the bottom of the plug hole, the correct amount of oil has been added. 3.
If the oil level is too low, install plug (F), operate the travel levers, and drive forward or in reverse to rotate the sprocket one turn. Then repeat Step 2 to check again. 4. If the oil level is still too low, add engine oil through the hole in plug (F) until the oil overflows. 5. After checking, install plug (F). 4-35