MAINTENANCE SERVICE PROCEDURE When Checking Electrolyte Level from side of Battery If it is possible to check the electrolyte level from the side of the battery, check as follows. 1. Remove nuts (2) (2 places) of cover (1), then remove the cover. 2. Use a wet cloth to clean the area around the electrolyte level lines and check that the electrolyte level is between the UPPER LEVEL (U.L) and LOWER LEVEL (L.L) lines. If the battery is wiped with a dry cloth, static electricity may cause a fire or explosion. 3. Remove cap (3), and check the battery electrolyte is up to the UPPER LEVEL line. If the level is low, add distilled water. Do not add water above the UPPER LEVEL line.
This may cause leakage of the electrolyte, which may cause fire. 4. Clean the air hole in the battery cap (3), then tighten the cap securely. Wipe the top surface of the battery with a damp cloth to keep it clean. REMARK When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electro- lyte from freezing. 4-37