MAINTENANCE SERVICE PROCEDURE EVERY 1000 HOURS SERVICE Maintenance for every 100, 250 and 500 hours should be carried out at the same time. CHECK OIL LEVEL IN SWING MACHINERY CASE, ADD OIL WARNING Raise the body. Fit the dump body support rod securely to prevent the body from coming down. The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Remove dipstick (G) and wipe the oil off with a clean cloth. 2. Insert dipstick (G) fully in the dipstick guide pipe, then take it out again. 3. The oil level should be between the H and L marks on dipstick (G). 4.
If the oil level is below the L mark, add engine oil through oil filler (F). When adding oil, remove air bleed plug (1). 5. If the oil is above the H mark, drain the excess engine oil from drain plug (P), and check the oil level again. 6. After inspecting the oil level and adding oil, insert the dipstick, then install air bleed plug (1). CHECK FAN BELT TANSION, ADJUST Special tools are required for inspection an replacement fan belt. Contact your Komatsu distributor for inspection and replacement. REMARK An auto-tensioner (a device to automatically adjust the fan belt tension) is installed, so it is not necessary to adjust the tension.
CHECK ALL TIGHTENING PARTS OF TURBOCHARGER Please contact your Komatsu distributor to have the tightening portions checked. CHECK PLAY OF TURBOCHARGER ROTOR Please contact your Komatsu distributor to have the rotor play checked. 4-45