Komatsu — CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS

SERVICE PROCEDURE MAINTENANCE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS WARNING If compressed air, high-pressure water, or steam hit your body directly, or they cause dirt or dust to be blown up, there is a hazard of serious injury. Always use safety glasses, dust mask, or other protective equipment. NOTICE When using compressed air, keep a suitable distance away to prevent damage to the fins. In particular, when cleaning the aftercooler by blowing with compressed air at an angle of 45є, make sure that the noz- zle is at least 300 (11.8 in) mm away from the radiator. As far as possible, blow the core with compressed air at right angles to the core.

If the fins are damaged, it will cause leakage of water and overheating. On extremely dusty jobsites, carry out the inspection every day, regardless of the maintenance interval. 1. Open engine front cover (1). 2. Use compressed to blow off mud, dust, or leaves clog- ging the radiator fins and oil cooler fins. At the same time, clean the net in front of the oil cooler. On machines equipped with an air conditioner, clean the condenser fins also. Steam or water can be used in place of compressed air. 3. Check the rubber hose. Replace with a new one if the hose is found to have cracks or to be hardened by age- ing. Further, check hose clamps for looseness. 4. Close engine front cover (1). 4-44