Komatsu — REPLACE HYDRAULIC LINE FILTER ELEMENT

MAINTENANCE SERVICE PROCEDURE REPLACE HYDRAULIC LINE FILTER ELEMENT WARNING Raise the body. Fit the dump body support rod securely to prevent the body from coming down. The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Remove drain plug (1) at the bottom of the filter case, drain the oil, then tighten the drain plug again. 2. Hold down case (2), loosen center bolt (3), then remove case (2). 3. Take out the element and wash the inside of the case. 4. Replace the filter gasket and O-ring with new parts.

Coat the gasket and O-ring thinly with clean engine oil before installing. 5. Assemble the new element, set the case in position, then install with center bolt (3). Tightening torque: 76.5 ± 11.8 N•m (7.8 ± 1.2 kgf•m, 56.4 ± 8.7 lbft) 6. Run the engine at idling for a short time, then check that the oil is at the specified level. For details, see "CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL (PAGE 3-39)". 4-43