SERVICE PROCEDURE MAINTENANCE CHANGE OIL IN FINAL DRIVE CASE WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before starting the operation. If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare the following. Container to catch drained oil: Min. 2.1 liters capacity Refill capacity: 2.1 liters (0.55 US gal) Prepare hexagon wrenches (Width across flats: 8 mm (0.3 in)). 1. Set so that the height of plug (F) is at the center of the final drive case, and so that plug (P) is lower than plug (F). 2. Set an oil receiving container under plug (P).
3. Remove plugs (P) and (F) (Two places) with hexagonal wrench (Width across flats: 8 mm) to drain the oil. 4. Tighten plug (P). 5. Supply oil through the hole of plug (F) up to the specified level. 6. After the oil flows out of the hole of plug (G), install plug (F). 4-42