MAINTENANCE SERVICE PROCEDURE 10. After bleeding the air, start the engine, and check that there is no leakage of oil from the filter seal circuit. If there is any leakage of oil, check the tightening of the filter cartridge. If there is still oil leakage, repeat Steps 1 and 2 to remove the filter cartridge, then check the packing surface for damage or embedded foreign mate- rial. If there is any damage or foreign material in the packing, replace the cartridge with a new part, then repeat Steps 3 to 9. CHECK SWING PINION GREASE LEVEL, ADD GREASE WARNING Raise the body. Fit the dump body support rod securely to prevent the body from coming down.
The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Remove bolts (1) (2 bolts) on the front of the revolving frame and remove cover (2). 2. Insert a scale into the grease and check that the height of the grease in the portion where the pinion passes is at least 4 mm (0.158 in). Add more grease if necessary. 3. Check if the grease is milky white. If it is milky white, it is necessary to change the grease. Please contact your Komatsu distributor. The total amount of grease is 5 liters (4.5 kg) (1.3 US gal) 4. Install cover (2) with bolts (1). GREASE SWING CIRCLE (2 points) 1.
Using a grease pump, pump in grease through the grease fittings shown by arrows. 2. After greasing, wipe off all the old grease that was pushed out. 4-41