Komatsu — REPLACE FUEL FILTER CARTRIDGE

SERVICE PROCEDURE MAINTENANCE EVERY 500 HOURS SERVICE Maintenance for every 100 and 250 hours service should be carried out at the same time. REPLACE FUEL FILTER CARTRIDGE WARNING Raise the body. Fit the dump body support rod securely to prevent the body from coming down. Engine is at high temperature immediately after the machine has been operated. Wait for engine to cool down before replacing the filter. Do not bring fire or sparks near the fuel. When carrying out automatic air bleeding, the engine may start, so be careful to check that the area around the engine is safe before cranking. Prepare a filter wrench and a container to catch the fuel. 1.

Set the container to catch the fuel under the filter car- tridge. 2. Using a filter wrench, turn filter cartridge (1) counterclock- wise to remove it. 3. Clean the filter holder, fill a new filter cartridge with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. 4. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it up 2/3 of a turn. NOTICE If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. 5.

After replacing the fuel filter cartridge, bleed the air. It is possible to bleed the air from the fuel circuit simply by cranking the starting motor with the starting switch. Bleed the air as follows. 6. Add fuel to the fuel tank until full (to FULL mark on the fuel gauge). 7. Set the fuel control lever to the low idling position. 8. Turn starting motor switch key to ON position, and crank the engine 15 - 20 seconds. Air bleed automatically with automatic air bleeding device. 9. Turn the starting motor switch key to START position, the engine runs. NOTICE Do not continue to crank the starting motor for more than 20 seconds. Wait for 1 or 2 minutes, then try again.

REMARK When the engine stops because of running out of fuel, also operate the above procedure to bleed air. 4-40