MAINTENANCE SERVICE PROCEDURE REPLACE HYDRAULIC FILTER ELEMENT WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the hydraulic tank strainer. When the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the internal pressure, then remove it carefully. 1. Open inspection cover (1) at the front of the chassis. 2. Remove the cap from oil filler (F), and release the internal pressure. 3. Loosen 3 bolts, then remove cover (2). When doing this, the cover may fly out under the force of spring (3), so hold the cover down when removing the bolts. 4.
After removing spring (3) and valve (4), take out element (5). 5. Clean the removed parts in diesel oil. 6. Install a new element in the place where old element (5) was installed. Check the O-ring to be set between the hydraulic tank and cover (2). If it is damaged, replace the O-ring. 7. Set valve (4) and spring (3) on top of the element. 8. Set cover (2) in position, push it down by hand, and install the cover with the mounting bolts. 9. Remove oil filler plug (F), then close cover (1). 10. To bleed the air, start the engine according to "START- ING ENGINE (PAGE 3-47)" and run the engine at low idling for 10 minutes. 11. Stop the engine.
REMARK Operate the machine after halting for more than 5 minutes to eliminate bubbles in the oil inside the tank. 12. Check for oil leakage and wipe off any spilled oil. 4-39