MAINTENANCE SERVICE PROCEDURE 2. Place a container under the drain plug under the chassis to catch the oil. Remove the plug of oil filler port (F) and drain plugs (P) and (Q), and drain the oil. Check the O-rings fitted to plugs (P) and (Q), and if any damage is found, replace the O-ring. After draining the oil, tighten drain plugs (P) and (Q) again. Tightening torque Drain plug (P) (installed to bottom of tank): 68.6 ± 9.81 N•m (7 ± 1 kgf•m, 50.6 ± 7.2 lbft) Drain plug (Q) (installed to piping):49.0 ± 4.9 N•m (5 ± 0.5 kgf•m, 36.2 ± 3.6 lbft) When removing drain plugs (P) and (Q), be careful not to get oil on yourself. 3. Loosen bolt (2), remove flange (3), then remove strainer (4). 4.
Remove all dirt stuck to strainer (4), then wash with clean diesel oil or flushing oil. If strainer (4) is damaged, replace it with a new part. 5. When installing, insert strainer (4) into the protrusion of flange (3) to assemble. 6. Add the specified amount of engine oil through oil filler port (F). Check that the oil level is between the H and L lines on sight gauge (G). 7. After changing the oil, or replacing or washing the filter element and strainer, bleed the air from inside the cir- cuit as follows. 4-47