SERVICE PROCEDURE MAINTENANCE AIR BLEEDING PROCEDURE 1. Bleeding air from pump 1) Loosen air bleed plug (1) installed to the drain port and check that oil oozes out (air bleeding is com- pleted). 2) After completion of the air bleeding operation, tighten the air bleed plug. NOTICE If the pump is run when the pump case is not full of oil, there will be abnormal generation of heat, and this will lead to premature failure of the pump. 2. Start the engine. For details, see "STARTING ENGINE (PAGE 3-47)". Run the engine at low idling for 10 min- utes, then do as follows. 3.
Bleeding air from cylinders 1) Run the engine at a low idling, and extend and retract the cylinders 4 to 5 times to a point 100 mm(3.9in) from the end of the stroke. (Be careful not to operate to the end of the stroke.) 2) Next, operate each cylinder 3 to 4 times to the end of its stroke. 3) Finally, operate each cylinder 4 to 5 times to the end of its stroke to completely remove the air. NOTICE If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder may cause damage to the piston packing. 4.
Operation 1) After completing the air bleeding operation, stop the engine, and leave it for at least 5 minutes before starting operations. This will release any bubbles in the oil inside the tank. 2) Check that there is no oil leakage. If any oil has been spilled, wipe it off. CLEAN, CHECK TURBOCHARGER Contact your Komatsu distributor for cleaning or inspection. CHECK ALTERNATOR, STARTING MOTOR The brush may be worn or the bearing may have run out of grease, so contact your Komatsu distributor for inspec- tion or repair. If the engine is started frequently, have this inspection carried out every 1000 hours.
CHECK ENGINE VALVE CLEARANCE, ADJUST As special tool is required for removing and adjusting the parts, you shall request Komatsu distributor for service. CHECK VIBRATION DAMPER Check that there are no cracks or peeling in the outside surface of the rubber. If any cracks or peeling are found, contact your Komatsu distributor to have the parts replaced. 4-48