Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS Starting Engine with Booster Cables When starting the engine with a booster cable, do as follows: Connecting and Disconnecting Booster Cables WARNING 3 - 125 Battery Charges battery is not handled correctly, may explode. Always follow the ATTERY (PAGE 3-123)" and the g the charger, and do as follows. o match the voltage of the battery ltage is not selected, the charger xplosion. rger clip of the charger to the ery, then connect the negative (-) the negative (-) terminal of the securely. When charging the battery, if the battery is not handled correctly, there is a hazard that the battery may explode.

Always follow the instructions of "DISCHARGED B ATTERY (PAGE 3-123)" and the instruction manual accompanyin g the charger, and do as follows. Set the voltage of the charger t o match the voltage of the battery to be charged. If the correct vo ltage is not selected, the charger may overheat and cause an e xplosion. rger clip of the charger to the Connect the positive (+) cha positive (+) terminal of the batt ery, then connect the negative (-) charger clip of the charger to battery. Be sure to fix the clips Set the charging current to 1/1 0 of the value of the rated battery capacity; when carrying out rapid chargin g, set it to less than the rated battery capacity.

If the charger current is too hig h, the electrolyte will leak or dry up , and t his may cause the b attery to catch fir e and explode. If the battery electrolyte is fro zen, do not charge the battery or start the engine with a different power source. ignite the battery electrolyte and cause the battery to explode. There is a danger that this will ignite the battery electrolyte and cause the battery to expl Do not use or charge the batte ry if the battery electrolyte level is below the LOWER LEVE L line. This may cause an explosion. Check the batte ry electrolyte level periodically an d add distilled water to bri ng the electrolyte level to the UPPER LEVEL line.

When connecting the cables, neve r contact the positive (+) and negative (-) terminals. When starting the engine with a glasses. booster cable, always wear safety Be careful not to let the normal m achine and problem machine contact each other. This prevents sparks fr om generating near the battery which could ignite the hydrogen gas giv en off by the battery. If hydrogen gas explodes, it could cause serious i njury. Be careful not to make a mistake when connecting a booster cable. In the last connection (to the upp er structure frame), a spark will be caused, so connect the cable to a spot as far away from the battery as possible.

(Avoid the work equipme nt, however, because it is not a good conductor) When removing the booster cab le, exercise good care so that the tact each other, or they contact the booster cable clips may not con chassis.