Komatsu — REPLACE WATER SEPARATOR ELEMENT

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE WATER SEPARATOR ELEMENT WARNING 4 - 26 Do not bring any fire o r flame c Prepare the filter wrench for water se parator. 1. Open th e inspection co ver (1) on the right side of t he machine, then se t handle (2) of th e filter insid e to CLOSED position (a). 2. Using a filter wrench, lo osen ring (3), then remove element cup (4) and take out elemen Be care ful not t o lose re d ring (6) in side the case. 3. Wash e lement c up (4) i n diesel fuel or flushing oil 4. Install n ew element (5). 5. Insert a red ring (6) into element co ver (4), fill wit h fuel, install to the fi lter holder, then tighten ring 6. Set han dle (2) t o the O PEN position 7.

After re placing t he elem ent, bleed t For deta ils of th e metho d for bleedin g the air , see " Air Bleeding (PAGE