. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE minutes. REMARK 4 - 70 6. Remove bolts (4), then r emove cover (5). When this is done, the c over may fly off und er the force of spring (6), so keep the cove r pushed down whe n removing the bolts. 7. After removing spring (6 ) and valve (7), take o ut e lement ( 8). 8. Clea n the rempved part 9. Insta ll the new element where old element (8) wa s installe Inspe ct the O-ring set b etween the hydraulic tan (5). I f there are any scr atches, replace the O-ring 10. Set v alve (7) and spring (6) on top of the element 11. Set c over (5) in positio n, hold it down by hand, an cove r mounting bolts (4) to install cover (5) 12.
Insta ll the cap of oil filler 13. Move (2). 14. Clos 15. To bl "STARTING ENGINE (PAGE 3-71)" and run the engine at low idling for 10 16. Stop Wai t for a t least 5 minutes a fter stopping the eigine to eliminat e bubbles in the oil inside th 17. Chec k for oil leakage an d wipe off any spilled oil.