. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE Rear CLEAN, CHECK RADIATOR FINS AND AFTER COOLER FINS WARNING around dust and debris, there of injury. Always wear protective equipment such as can be 4 - 59 If c ompresse d air scattere protective glasses and mas is danger If the radiator fins bec ome clogged o r bent, this may cause overheating of the engin e, so always cle an or ca rry out inspection and t ake th e necessary actions. Cleaning can be carrie d out by using j ets of air , steam, or water, but be careful not to le t the nozzle co ntact the fin. When using compress ed air or steam, keep th e nozzle at a right angle to t he radiator a nd after cooler.
Examine the rubber h found, replace the ho ose, and if any c se. In addition, racks or check al brittle so for plac loose es are hose clamps. NOTIC If s tea damaged, so keep a good d istance in betwee n when c leaning Use th e following values as a benchmark. Jet pressure: Lower than 9.8 MPa (100 kg/ Nozzle diameter: Less th an 2 mm (0.08 in) Distance b etween nozzle and fin (A): More than 100 mm (4 in