Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 7. Loosen wing bolt (4) which is fixing lever (5) of priming pump (3). Move lever (5) up and down to let fuel flow out of air bleeding plug (2) until bubbles do not come out any more. 8. Tighten air bleeding plug (2) and then tighten wing bolt (4) of Tightening torque for air bleeding plug 7.8 to 9.8Nm{0.8 to 1kgm} Tightening torque for wing screw 6.9 to 12.7Nm{0.7 to 1.3kgm} priming pump (3) securely to lock lever (5). REPLACE FUEL TANK BREATHER ELEMENT WARNING Immediately after the engine is stopped, the oil and parts are at high temperature, and this will cause burns.

Wait for the temperature to go down before starting the operation. 3. Install cover (3) and nut (2). 4 - 64 9. After replacing the filter eck that there is no leakage of fuel from the filter seal surfac e. If there is any leakage of fuel, check the tightening o f the filter cartridge. If there is still l eakage of fuel, follow Step 1 and 2 to remove the filter cartridg e, then check the packing s urfac e for damage or foreign mate rial. If any damage or foreig n material is found in the packing, replace the cartridge with a part, then repeat Steps 3 - 9 t o install the filter cartridge. 1. Remove nut (2) of breat her assembly (1) at the top surfac e of the fuel tank, then remo 2.

Replace breather eleme