. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION FILTER ELEMENT WARNING cause burns. Wait for the VALVE SIDE Prepare a filter wrench cartridge thinly with clean oil, then install it. 4 - 65 The parts and oil are at high te mperature immediately after the engine is stopped, and ma arting the work. turn it slowly to release the internal pressure, then remove it. temperature to go down before st When removing the oil filler cap, 1. Set the container to catch th e oil under the filter case. he filter head, drain the oil, then 2. Remove drain plug (1) at t tighten the plug again. 3. Using a filter wrench, turn filte r cartridge (2) to the left to remove 4. it.
Clean the filter head, coat the seal surface of the new filter 5. Add oil. For details, see "CH ECK OIL LEVEL IN TRANSMISSION CASE, ADD OIL BRAKE COOLING SIDE e cover (2). 1. Remove bolt (1), then remov 2. Set the container to catch th e oil directly under the drain plug (P). Remove drain plug (P), dra again. Take out the element, then removed parts. in the oil, then tighten the plug clean the inside of the case and install cover (2) with bolt (1). ee "CHECK OIL LEVEL IN D OIL (PAGE 3-74)". bleeder screw (3), then insert a 3. 4. Install the new element, then 5. Add oil. For details, s TRANSMISSION CASE, AD 6. Remove the cap installed to vinyl hose.
Prepare a contai ner with oil in it and insert the other end of the hose approx. 50 m m (2.0 in) below the surface of the oil. (Use any commercially available vinyl hose.) eder screw (3) approx. 3/4 turns, 7. Start the engine, loosen ble and keep the engine running at idling until fewer bubbles come out from the vinyl hose. operly, then install the cap. e transmission case is up to the 8. Tighten bleeder screw (3) pr 9. Check that the oil level in th specified level. Add oil if the level is low. 10.