. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN TRANSMISSION CASE WARNING the engine is stopped, and may cause burns. Wait for the (P). Remove 2 drain plugs (P), drain the oil, then tighten the plug again. brake of oil the oil any 4 - 66 T emperature to go dow n before starting the wo When removing the oi l filler cap, turn it slowly to release the in R efill capacity: 115 liters (30.38 US gal) (i ncluding oil in the brake oil tank and each filter c Carry out the following items at the same tim e in order to d rain oil completely.
E 4-65) REPLACE TRANS MISSION FILTER EL EMENT (PAG CHANGE OIL IN T RANSMISSION CASE (PAGE 4-66) CHANGE OIL IN B RAKE OIL TANK, RE PLACE BRAK E OIL FILTER ELEMENT (PAGE 1. Set the container t o catch the oil directly under the dra REMARK When changing oil in the brake oil tank and replacing the filter element, carry ou BRAKE OIL TANK, R (PAGE 4-68)". t steps 1 to 5 mentioned in "CHANGE EPLACE BRAKE OIL FILTER ELE NOTICE Do not start up the engin e without the transmissio n being filled wi the engine is started up w hile the transmission is e mpty or short o transmission hydraulic p ump will suffer damage. 2.
Before starting the through oil filler po When oil is added engine, add 90 liters (23.78 US ga rt (F). , the level will temporarily go above 3. 4. level on sight ga abnormality. Start the engine a Add oil through oil uge (G), but this does not indica nd run at low idling. filler port (F) until the oil level is betw H and L marks on sight gauge (G).