. MAINTENANCE SERVICE PROCEDURE approx. 50 mm into a come out from the vinyl tighten bleeder screw (1) NOTICE level so that it reaches the 4 - 67 Make sure that the oil level in the brake o il tank does not go down below the mark in th engine is running at low idling. If the oil le vel goes down below (H) mark, stop the engi the brake 5. Remo ve the cap from bleeder screw (1 (Use a commercially available vinyl h 6. Put th e other end of the vinyl hose ner of oil. contai 7. Loose n bleeder screw (1) approx. 3/4 at low idling until no more bubbles c no more bubbles come out, ti hose. 8. When secur ely, remove the vinyl hose, then 9.
Carry out the warming-up operation o f the engine until the torque converter oil tem 40°. 10. When the torque converter oil temper Front brake:See "BLEED AIR FROM Cente r brake:See "BLEED AIR FRO Rear brake:See "BLEED AIR FROM D o not a ttempt to use the oil drained during air bleeding again. Such a practice can cause dam quipme M ake su re that the oil level in the brake oil tank does not go down below (H) level in the sight oes, th e brake oil pump could be damaged 11. After f specif ied level. For details, see "CHE CK OIL LEVEL IN TRANSMISSION CASE,