. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN BRAKE OIL TANK, REPLACE BRAKE OIL FILTER ELEMENT WARNING cause burns. Wait for the Remove drain plug (P), drain the oil, then tighten the plug again. O-ring of 4 - 68 The parts and oil are at h igh temperature immediately after the engine is stopped, and ma fore starting the work. r cap, turn it slowly to release the internal pressure, then remove it. temperature to go down be When removing the oil fille r cap, turn it slowly to release the in Prepare a filter wrench Refill capacity:
115 liters (30.38 US gal) (including oil in the transmission case and e Carry out the following item s at the same time in order to REPLACE TRANSMIS SION FILTER ELEMENT (PAG CHANGE OIL IN TRAN SMISSION CASE (PAGE 4-66 CHANGE OIL IN BRAK E OIL TANK, REPLACE BRAK E OIL FILTER ELEMENT (P 1. Depress the brake ped al at least 20 times to reduce th e pressure inside the brake c ontrol accumulator t 2. Set the container to ca tch the oil directly under drain p 3. Set a container to catch the oil immediatelyunder the fil (1), then remove filter c 4. Take out the element a nd wash the inside of the filter Replace O-ring (2) and backup ring (3) on the filter ca ith clean oil, then install.
ent in the filter case, coat the O clean oil, then install. to 98 Nm 2.3 lbft} new parts, coat thinly w 5. Assemble a new elem the element thinly with Tightening torque: 78.4 {8 to 10 kgm, 57.9 to 7