Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE REMARK Steps 6 to 8 are identical with those in "CHANGE OIL IN TRANSMISSION CASE (PAGE 4-66)". NOTICE Do not start up the engine without the transmission being filled with oil. If the engine is started up while the transmission is empty or short of oil, the transmission hydraulic pump will suffer damage. 4 - 69 6. Before starting the engine , add 90 liters (23.78 US gal) of oil through oil filler port (F). When oil is added, the lev el will temporarily go abo ve the oil level on sight gauge (G), b any abnormality. at low idling. 7. Start the engine and run 8.

Add oil through oil filler po rt (F) until the oil level is between the H and L marks on sigh Make sure that the oil lev el in the brake oil tank do es not go down below the mark in th the engine is running at lo w idling. If the oil level go es down below (H) mark, stop the level in the brake oil tank. REMARK Steps 9 through 11 are identi cal with those in "CHANG E OIL IN TRANSMISSION CASE ( 9. Carry out the warming-up operation of the engine u ntil the torque converter oil tempera 40°. er oil temperature gauge rises to 40°, bleed the air from the b 10. When the torque convert er oil temperature gauge r Front brake:See "BLEED AIR FROM FRONT BRA KE (PAGE 4-32)". RAKE (PAGE 4-33)".

E (PAGE 4-34)". Center brake:See "BLEE D AIR FROM CENTER B Rear brake:See "BLEED AIR FROM REAR BRAK NOTICE D o not attempt to use the oil d rained during air bleeding ag ain. Such a practice can cause damage e quipment. M ake sure that the oil level in the brake oil tank does not g o down below (H) level in the sight gau d oes, the brake oil pump coul d be damaged.