Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE LUBRICATING PARKING BRAKE WARNING the braking capacity. For details, see "CHECK BRAKING CAPACITY OF PARKING BRAKE (PAGE 4 - 71 When ca rrying out maintenance, raise the brake oil pre ssure sufficientl y to p revent the parking br ake from being a utomatically applied. In addition, hang a warn ing tag that can be se en clearly to prevent any other person from operating the p arkin g brake switch. Do not g et any oil or grease on t he brake disc or pad 1. Stop the machine in a flat place and put the blocks under the tires to prevent the machine from moving. 2. Raise the dump body and secure it in position with the body pivot pin. 3.

Before starting operations, raise the brake oil pressure sufficiently to prevent the parking brake from being automatically applied, and check that the brake pressure caution lamp is not lighted up. 4. Release the parking brake and stop the engine. 5. Using a grease pump, pump in grease through fittings (1) and (2) (2 places) in the parking brake body. NOTICE Do not use air pressure or oil pressure to carry out high-pressure greasing. 6. After completing the greasing operation, remove fitting (1). If grease comes out, wipe off all the grease that comes out. REMARK Removing fitting (1) makes it possible to release the abnormal internal pressure created by excessive greasing. 7.

If no grease comes out, install fitting (1). Do not use air pressure or oil pressu re to carry out high-pressure gr easing. 6. After completing the greasing operation, remove fitting (1). If grease comes out, wipe off all the grease that comes out. REMARK Removing fitting (1) makes it possible to release the abnorma internal pressure created by excessive greasing. 7. If no grease comes out, install fitting (1). 1. Stop t he machine in a flat p lace and put the bl ocks und er the tire s to prevent the ma chine from moving 2. Raise the dump body and s ecure it in position with the body p ivot 3.

Befor e starting operations, raise the brake oi l pressur automatically applied, and check that the brak e pressur e caution lamp is not lighted 4. Relea se the parking brake and stop the engin 5. Using a grease pump, pum p in grease through fittings ( 1) and (2) (2 places) in the parking 6. After completing the greasi ng operation, remo ve fitting ( If grea se comes out, wipe o ff all the grease th at comes Removing internal pr essure created by ex 8. Chec 4-53)"