. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF BRAKE DISC WARNING it depressed, and push in the rod (2) enters beyond guide end wear limit, please contact your 4 - 72 Carry out this check when the brak e oil temperature is below 60°C (140° I f the disc wear approaches the we ar limit, check the condition frequently , regardless of the mainten ance interval. In addition, check the retarder capacity careful 1. Stop the machine on level gr ound, set the parking brake switch to the PARKING positio n, then check tha t the other brakes are not applied before starting inspection. nd check that the retarder oil pressure caution lamp is out. 2.
Turn the starting switch ON a nd check that the retarder oil pressure caution lamp is out I f the retarder oil pressure cau tion lamp is lighted up, start the engine, run the engine at 20 00 rpm, and if the lamp goes out, turn the starting sw 3. 4. Depress the brake pedal, kee r od (2) of the gauge until cont 5. I f mark (3) at position "A" of r f I ace (4), it means that the dis f the disc has reached the Komatsu distributor for inspe 6. Tighten cap nut (1) removed Tightening torque: 14.7 to 19. (1.5 to 2.0 Tightening torque: 14.7 to 19.
REMARK With new machines, the positi on of the guide is adjusted so that mark (5) comes to end f ace (4) of the guid e, so d o not loosen locknut (6) exce pt when replacing the disc. o workers. One worker depresses the brake pedal and the other pushes in the Carry out the operation with tw o workers. One worker depresse s the brake pedal and t rod. If the rod is pushed in when th e engine is running, the rod will be pushed back by the brak e cooling oil pressure, s o always carry out this opera tion with the engine stopped. three places (A, B, C), but on this machine, use the mark at position A. There are marks on the rod at three places (A, B, C), but on this machine, use the mark