General 433 Fault Cause Remedy Warning Light Comes on while travelling. Tank pressure inadequate or Watch double brake pressure Important: Stop immediately. non-existent, gauge until tank pressure is rea ched. Check compressed air sy stem for leaks, sealing if neces sary. Leakage in hydraulic brake cir- Rectify leaks, bleeding brake sy cuit. stem if necessary. Check fluid level, correcting if necessary. Brake pad/lining wear. Replace brake pads/linings. Check fluid level, correcting if necessary. Warning light does not come on Bulb defective. Fault in electrical Replace bulb. Rectify electrical when pressure drops below war- system. fault. ning level.
Air Brake Servo Unit Compressed air escapes at vent Intake valve leaking. Replace intake valve. in released position. in partial and full braking posi- seals leaking. rings and seals, exchanging ser tions. vo unit if necessary. Compressed air escapes at vent Exhaust valve, sealing rings and Replace exhaust valve, sealing Wheel brakes are slow to relea- No pedal play. Adjust pedal play. se after braking. Inner stiffness between piston Check brake servo unit, repla and cylinder bore. Compression cing if necessary. spring weak. Control piston sticking in 3/2- Check 3/2-way valve, replacing f way valve changeover valve for necessary. trailer working. Brake graduation not fine Pedal system stiff.
Check brake servo unit, repla enough. cing if necessary. Inner stiffness between piston Check brake servo unit, repla and cylinder bore. cing if necessary. H db k V l