mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Control Equipment 43.3 Defroster 2 Part No. Westhinghouse Designation 4321990100 4321990300 000431 2115 000431 2615 Technical Data 1 Defroster Oper. pressure max. 0004312115 000431 2615 10.0 bar 20.0 bar -5 Temperature range -30 ° C to -40 ° C to +70 °C +80 °C Approved antifreeze Ethyl alcohol fuel alcohol or denaturated alcohol Z42 - O9Q UZ 43-0074 Container capacity 200 cc Defroster 00 431 2115 1 Connection, pressure regulator 2 Tommy handle 3 Dipstick 4 Connection, compressed air tank 5 Housing Maintenance which should be slightly raised so that air can escape from the container.

The filter hole is then closed again,the rod is unlocked with the Tommy handle and moved into the antifreeze position. When in opera tion,the fluid level must be checked with the dipstick which has a mark to indicate the maximum permissi ble level. Completely drain contents at least once a year during the autumn inspection and renew. Check regularly after specified service intervals and top up, For adding antifreeze and for checking the quantity of antifreeze still available - and in months free of frost - the rod is pushed with the Tommy handle against the throttle stop in housing and locked by turning 90 °.

The closing plug with dipstick is released and the antifreeze ethyl alcohol fuel alcohol is filled in. With the closing plug removed, a slight blowing-off caused by the pressure compensation bore is noticed. It is therefore recommended to use a funnel for filling, if necessary. Prior to start of frosty weather, clean inner parts of antifreeze unit. Compressed Air Tank Removal and Installation Inspection 1 Make system pressureless. Inspection essentially covers the following points: 2 Unscrew pipeline from pressure regulator to tank. 1 General leak test test pressure 9.6 bar in acc. with DIN 74281. 3 Unscrew line to double pressure gauge and control valve. 2 No paint peeling off inside.