mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

43.3 Control Equipment Brake Booster the piston of the master hydraulic brake cylinder and the piston rod of the single-chamber brake booster must be at least 1 mm so that the compensating bore in the master cylinder is definitely open. The stroke of the master brake cylinder should never be less than that of the brake booster since otherwise damage would result to the inner parts of the master brake cylinder. When the brake is correctly adjusted, the piston stroke is approx. 1/3 of the specified total stroke. Removal and Installation 1 Remove master brake cylinder. 2 Loosen compressed air connections on brake booster. 3 Booster is removed without disassembling brake pedal.

The three fastening nuts are accessible from pedal end pay attention to snap rings. Partial Disassembly and Repair aQ4m967 UZ 43-OO6 70 80 Spare parts for brake booster 1 Unscrew the eight fastening bots M 8 for the cylinder base. First mark position relative to hou sing. Proceed carefully, since base is under spring pres sure. If required, replace protective strainer in venting hole. 5 Remove locking ring of control piston and pull thrust piece out of control piston Pay attention to cord sealing ring. 6 Remove spring and valve disk or replace. No further disassembly is required. Return units with major damage to manufacturer for repairs.

2 Pull out entire piston group including plunger, sleeve and sealing rings. 7 Assembly is performed in the reverse sequence after checking individual components. First grease sliding surfaces of sleeves with special grease. 3 Sleeve 71 can be pulled off and replaced. Clean internal parts only with ethyl alcohol! Note: Ensure that inside paint coat is not damaged.