82.1 Adjusting headlamps SA 35343 Adjusting auxiliary headlamps 1 Check tyre pressure, adjust as required. 2 Park vehicle on even surface. 3 Make headlamp adjuster ready for service accor ding to instructions of manufacturer. 4 Exchange plug 1 against plug 2 in engine compartment. 5 Check headlamp adjustment. If headlamps requi re to be adjusted, release nut and adjust accordingly. 6 If no headlamp adjuster is available, set up vehicle on an even place 5 m distance from a vertical wall or other test surface. Position central and adjusting marks with division marks according to legend on wall test surface.
H 5/6 Height centre of headlamp at test surface H 6/6 Height centre of headlamp at vehicle H Height division mark e Adjustment 5 cm P Test surface S Standing surface Z Central mark E Adjusting mark T Division mark K Cutoff point 15 ° A Distance between centre of beams L Distance 5 m - test surface - headlamp I A P 7 Switch on main beam and individually check headlamp adjustment. The centre of beams must lie on the central mark "Z", adjust headlamps as L