PTO Shaft Re-Locating Transmission 55-4 12 4 3 Picture 55-4/1 1 = Tension screw 2 = Mounting bracket with washer 3 = Tension lever, tensioned 4 = Re-located pto The pto. shaft re-locating transmission is a gear type driven one, running in oil in a closed housing. The pto. shaft splined outlet is of 1/8" designe. 2. The loose included parts for mounting the transmission onto the clamping bracket should be assembled first. Adjustment of the tensioning screw must be done on the first installation only, same goes for adjust ment of the stop screw for tension lever. Since this transmission is mostly installed on the pto. rear afterwards, we will describe a mounting installation procedure.
Required is a right angle mounting to avoid unequal ten sion on the transmission housing. The support itself is mounted on the trans mission with 2 screws M 10x20. 1 Mount the clamping bracket for the quick 3. Adjustment of tension screw a Slide transmission onto the well cleaned