mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

D. Power lift arm linkage, remove, install and repair 1. Remove rear wall and inserted floor. 6. The forward located intermediate shaft right and left can be taken out by de locking and removing a tightening screw on the outside lever. The shaft with inter mediate levers can now be taken out. 2. Decotter pin of fork head on lifting cylinder right and left. Now remove same. 3. Decoter nut right next to it on both sides and unscrew. Remove washer and connec tion piece for the lifting shaft. Remark: On the reenforced execution, as of chass. no. 5501620, both levers are united and can be removed to the outside, after taking off a lock ring. 4.

Remove on bottom side of frame the mounting brackets for power lift arm shaft, 4 hex, screws each. Take off brackets, watch intermediate ring, the unversal mostly remains on shaft, look out for shims. 7. The mounting bracket for intermediate shaft is tightened with two vertical positioned screws, after unscrewing both, the shaft can also be taken out. 5. Pull power lift arm shaft downwards, remove connection plate after taking off snap ring. 8. Installation is done vice-versa.